Posts related Medisoft software.
-
Shelly.s
- Posts: 15
- Joined: Mon Dec 29, 2014 10:18 am
Post
by Shelly.s » Thu Oct 20, 2016 4:56 pm
I have added some new ICD10 codes this week and noticed today when I try to key them in transaction entry, they won't populate. I then went to the Diagnosis code list and tried to find the codes and they don't show up. I tried to enter the codes again, and it says the code already exists. Is there a glitch? Any idea how I can get to the codes? Thank You.
-
Gavin Walker
- Posts: 4625
- Joined: Wed Apr 04, 2007 10:11 pm
- Location: Springfield, MO
-
Contact:
Post
by Gavin Walker » Thu Oct 20, 2016 5:26 pm
In Program Options -> HIPAA/ICD-10 tab, make sure Default New Diagnosis Version is set to ICD-10 and that you have the ICD-10 code field filled out on your diagnosis codes.
Gavin Walker
Walker Tek Solutions, LLC
417-890-6777 x0
fax: 417-763-6386
-
Shelly.s
- Posts: 15
- Joined: Mon Dec 29, 2014 10:18 am
Post
by Shelly.s » Mon Oct 24, 2016 11:46 am
My HIPAA code set is indicated as ICD10. I can't pull up the code to see if it is entered in the ICD10 block. That's the problem. How can I get it to pull up?
Thank You.
-
Shelly.s
- Posts: 15
- Joined: Mon Dec 29, 2014 10:18 am
Post
by Shelly.s » Mon Oct 24, 2016 11:57 am
I figured it out. In the Diagnosis List Screen, I had to uncheck Display ICD-9 Codes and Display ICD-10 Codes for the new codes to show up on the list. I had not entered the new code in the ICD10 block, so I corrected that and it works properly now.
Thank You.