Page 1 of 1

Info printing on 02/12 forms

Posted: Wed Feb 07, 2018 4:11 pm
by CathyB
Just started using v22 last month. We still print insurance forms. Forms were printer my great, yesterday went to print forms and the print is all out of alignment and smaller print. Any ideas about what happened? And how to get back to where it was.
Thanks!

Re: Info printing on 02/12 forms

Posted: Thu Feb 08, 2018 9:59 am
by Gavin Walker
Cathy, if you purchased your Medisoft from us or at least a month of support, then private message me and I'll send over our knowledge-base article about this. Following our guide, you should be able to align your printer in about 15 minutes.