Encoder Pro

Technical problems with Medisoft.
Post Reply
munawar1881
Posts: 3
Joined: Mon May 21, 2007 9:58 am

Encoder Pro

Post by munawar1881 » Tue May 22, 2007 8:42 am

I did that but still cannot see the Encoder Pro tab there. There is a space between cancle & help tab but Encoder tab is not there.
Munawar Hussain

User avatar
Gavin Walker
Posts: 4625
Joined: Wed Apr 04, 2007 10:11 pm
Location: Springfield, MO
Contact:

Post by Gavin Walker » Tue May 22, 2007 9:07 am

Munawar, if you are using Encoder Pro 2006 with Medisoft v10, then you can click this Encoder Pro 2006 Update.

Also, if you are getting an error message such as \"Medisoft Encoder Pro must be registered through Medisoft\" when you first startup Medisoft, then the buttons will not display until the module is registered.
Gavin Walker
Walker Tek Solutions, LLC
417-890-6777 x0
fax: 417-763-6386

munawar1881
Posts: 3
Joined: Mon May 21, 2007 9:58 am

Encoder Pro

Post by munawar1881 » Wed May 30, 2007 11:15 am

can you kindly tell me how to register module. right now my both Medisoft & Encoder pro is registered in medisoft.

I think that there is command like register /epax or epax /register kindly let me know the correct command to register

Thank you
Munawar Hussain

User avatar
Gavin Walker
Posts: 4625
Joined: Wed Apr 04, 2007 10:11 pm
Location: Springfield, MO
Contact:

Post by Gavin Walker » Wed May 30, 2007 12:02 pm

If it is registered in Medisoft, then you don't need to register it again. If it is not registered, then the error message will pop-up whenever you lauch Medisoft.
Gavin Walker
Walker Tek Solutions, LLC
417-890-6777 x0
fax: 417-763-6386

Post Reply