Page 1 of 1

Revenue Management setup

Posted: Wed Nov 27, 2013 3:30 pm
by ndewitt
I created a file as instructed by Revenue Management, but not sure how to connect it with the Medisoft database without screwing it up. I get an error message that "Revenue Management needs to be opened inside Medisoft". Where do I put the file so that Revenue Management recognizes it?

Re: Revenue Management setup

Posted: Wed Nov 27, 2013 4:49 pm
by Gavin Walker
Are you launching Revenue Management from the Activities menu within Medisoft?

Re: Revenue Management setup

Posted: Fri Nov 29, 2013 8:16 am
by ndewitt
Yes I opened it from the Activities menu. I was able to move the the RM file to Medidata file, but now I get the 5004 error.

Re: Revenue Management setup

Posted: Fri Nov 29, 2013 9:08 am
by ndewitt
I read to resolve the tblPINS: Error 7041 I needed to change the file name from HCFAfile.exe to CMSfile.exe in my EDI list. This worked to create my file for ENS. I opened the file and it looks perfect, however when I upload the file to ENS, it did not transfer the service dates (but they dates were there when I reviewed the file for accuracy).

Re: Revenue Management setup

Posted: Sat Nov 30, 2013 12:13 pm
by Gavin Walker
File Name should be RCM\RevenueManager.exe for ANSI 5010 claims. CMSFile.exe is being phased out with ICD-10 and Medisoft v19. You can use CMSFile for a while, but ENS will need to remap. There is no mapping step with your clearinghouse if you use ANSI 5010 claims.

Re: Revenue Management setup

Posted: Mon Dec 02, 2013 8:53 am
by ndewitt
When I change the file name, I get the 5004 error, again. So, with Medisoft V19 I have to use Revenue Management? How do I get past these errors in RM? Also, I purchased V18 with pre-order V19. When will V19 ship? I don't want to get comfortable with V18 and have to set things up again in V19.

Re: Revenue Management setup

Posted: Mon Dec 02, 2013 9:24 am
by Gavin Walker
Did you previously have Network Pro and you are stepping back to the Basic Edition of Medisoft? Try disabling your anti-virus. Your v19 serial # has been assigned. We are in the process of shipping out all the v19 pre-release orders. If you are in a hurry, you may download your Medisoft v19 from here. I suggest using the Patient Accounting ISO link which will prompt you to burn your own disk.

Re: Revenue Management setup

Posted: Mon Dec 02, 2013 9:36 am
by ndewitt
I had Medisoft V7 prior. No anti-virus running. No hurry on the V19, just not wanting to get V18 fixed and then switch to V19 and start over with errors.