Page 1 of 1
Packing MWAUDM.ADT
Posted: Sat Nov 14, 2015 9:07 am
by drk
I have noticed that MWAUDM.ADT takes extremely long time to pack -- it is only 27MB, and file maintenance has been sitting at 9% for over 30 minutes. I have turned off all the audits, but it still happening.
Is this normal or expected? If not, how can I fix this?
Re: Packing MWAUDM.ADT
Posted: Sat Nov 14, 2015 9:22 am
by drk
I should also add that MWTRN is 110 MB and only takes a few seconds to pack. All the processses do complete normally after that long delay.
Re: Packing MWAUDM.ADT
Posted: Mon Nov 16, 2015 4:59 pm
by Gavin Walker
Are you packing the table using Medisoft File Maintenance or using ARC32? It could be data corruption I supposed.
Re: Packing MWAUDM.ADT
Posted: Mon Nov 16, 2015 6:22 pm
by drk
I am using Medisoft File Maintenance.
Re: Packing MWAUDM.ADT
Posted: Tue Nov 17, 2015 3:45 pm
by Gavin Walker
You'll probably need to work with a Medisoft re-seller who can do a data repair for you. Private message me the version of Medisoft you are on and I can send you a quote. You'll probably be fine if you leave all of your audit functions turned off until the next time you need to upgrade.