Important News: McKesson Practice Interface Center (MPICâ„¢)

Posts related to Medisoft Clinical go here. You should consult with your Medisoft Clinical VAR if you are unsure about any configuration changes suggested here.
Post Reply
User avatar
Gavin Walker
Posts: 4625
Joined: Wed Apr 04, 2007 10:11 pm
Location: Springfield, MO
Contact:

Important News: McKesson Practice Interface Center (MPICâ„¢)

Post by Gavin Walker » Wed May 15, 2013 3:15 pm

As McKesson mentioned during the November 2012 MIX presentations, Medisoft® Clinical v19 and Lytec® MD v2014 will no longer utilize Communications Manager. MPIC™ will be used as an integration engine for Demographics, Appointments, and Billing Interfaces between the McKesson Practice Management System and the McKesson EMR only.

You can upgrade to the MPIC integration engine (at no cost) if you are on the following Medisoft Clinical or Lytec MD versions:
  • Medisoft Clinical v18 and above
    Lytec MD v2013 and above
To upgrade to the MPIC integration engine, click the appropriate link in the following table. After opening the zip file, refer to the MPIC Installation and User’s Guide to install and configure the MPIC.

Note: Existing installations of the Communications Manager software will not be affected. Please refer to the table below.

Version - Interface Engine - Action to Take - Software
Medisoft Clinical v17 (All Service Packs) - Communications Manager Only - No Impact -
Medisoft Clinical v18 (SP2 and Above) - Communications Manager or MPIC - Recommend Upgrade to MPIC - MPIC 32 Bit Installation or MPICSetup V1.1 x64.zip
Medisoft Clinical v19 (All Service Packs) - MPIC Only - Required Upgrade to MPIC -
Lytec MD v2012 (All Service Packs) - Communications Manager Only - NO Impact -
Lytec MD v2013 (SP2 and Above) - Communications Manager or MPIC - Recommend Upgrade to MPIC - MPIC 32 Bit Installation or MPICSetup V1.1 x64
Lytec MD v2014 (All Service Packs) - MPIC Only - Required Upgrade to MPIC -
Gavin Walker
Walker Tek Solutions, LLC
417-890-6777 x0
fax: 417-763-6386

UmerRazi
Posts: 3
Joined: Fri Mar 15, 2013 11:00 pm

Re: Important News: McKesson Practice Interface Center (MPIC

Post by UmerRazi » Fri Jan 17, 2014 10:37 pm

Can mpic be configured for third party EMR, that is sending HL7 text message into predefined folder from where EMR is pickingup

Post Reply