Page 1 of 1

Claim Forum

Posted: Wed Oct 21, 2015 10:56 am
by ytyutyunik
Hello. Printing out paper claim, diagnosis codes are not showing up.
Thank you

Re: Claim Forum

Posted: Wed Oct 21, 2015 11:29 am
by Andrew
Are you using a new claim form CMS 1500 01/12?

Re: Claim Forum

Posted: Wed Oct 21, 2015 11:57 am
by ytyutyunik
Both

Re: Claim Forum

Posted: Thu Oct 22, 2015 10:51 am
by Andrew
Both what? Are the insurances set to ICD10 with effective date of 10/1? Are the codes you are using filled with ICD9 and ICD10 codes?

Re: Claim Forum

Posted: Thu Oct 22, 2015 2:36 pm
by ytyutyunik
I use Icd-9 and old and new version of the claim form. I notice recently that diagnosis codes do not appear anymore, before October 1.

Re: Claim Forum

Posted: Thu Oct 22, 2015 5:33 pm
by Gavin Walker
As a default, ICD-9 codes do not map to ICD-10 codes. You must setup a code that is mapped to an ICD-10 code.

Re: Claim Forum

Posted: Fri Oct 23, 2015 10:25 am
by ytyutyunik
Gavin, I am printing claims for month of August and no diagnosis codes are showing up. My question what can possibly happen to the report set up?
I am not concern about mapping codes. They are mapped as I enter new Icd-10.
Thank you

Re: Claim Forum

Posted: Fri Oct 23, 2015 6:24 pm
by Gavin Walker
Well, you better be concerned about code mappings because that is the way Medisoft works. Assuming you have the ICD-10 cut-over date setup properly on the insurance and the end date of service occurs before that cut-over date, then Medisoft should be calculating that you need ICD-9s on your claims. So for the diagnosis code you are typing, what do you have in the ICD-9 column? That is what is supposed to print.